Manufacturer: POR-15 Inc., P.O. Box 1235, Morristown, NJ 07962-1235 Telephone: 973-887-1999
Factory: 64 South Jefferson Road, Whippany, NJ 07981
Emergency Telephone No: 973-887-1999, 800-457-6715, 973-539-3236, Chemtrec 800-424-9300

PRODUCT NAME: POR-15 SOLVENT CHEMICAL NAME: Aromatic Hydrocarbon Cas # 90641-13-7

PRODUCT DESCRIPTION: Clear Colorless Liquid CHEMICAL FAMILY: Petroleum Hydrocarbon

II. COMPOSITION/INFORMATION ON INGREDIENTS

This product is combustible as defined in 29 CFR1910 1200, based on the following compositional information:

OSHA COMBUSTIBLE COMPONENT

OSHA PEL; ACGIH TLV Petroleum Hydrocarbons

OSHA PEL; ACGIH TLV Trimethylbenzene

OSHA PEL; ACGIH TLV Xylene

OSHA PEL; ACGIH TLV Cumene

OSHA PEL; ACGIH TLV Ethylbenzene

III. HAZARDS IDENTIFICATION

POTENTIAL HEALTH EFFECTS
EYE CONTACT: Slightly irritating but does not injure eye tissue.
SKIN CONTACT: Frequent or prolonged contact may irritate and cause dermatitis. Low order of toxicity. Skin contact may aggravate an existing dermatitis condition.
INHALATION: High vapor/aerosol concentrations (greater than approx. 1000ppm) are irritating to the eyes and respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death.
INGESTION: Small amounts of this product aspirated into the respiratory system during ingestion or vomiting may cause mild to severe pulmonary injury, possibly progressing to death. Minimal toxicity.

IV. FIRST AID MEASURES

EYE CONTACT: Flush with large amounts of water until irritation subsides. If irritation persists, get medical attention.
SKIN CONTACT: Flush with large amounts of water, use soap if available. Remove and wash contaminated clothing before re-use.
INHALATION: Immediately remove victim from exposure. Administer artificial respiration if breathing is stopped. Call for medical attention.
INGESTION: Do not induce vomiting. Keep at rest. Get prompt medical attention.

V. FIRE FIGHTING MEASURES

FLASH POINT (Method used): TCC 104 Degrees F / 40 Degrees C Note: Minimum
Auto Ignition Temperature: 880 Degrees F / 471 Degrees C NOTE: Approximate
FLAMMABLE LIMITS: LEL: 1.9 UEL: 12.6 @ 77 Degrees F / 25 Degrees C
GENERAL HAZARDS: Combustible liquid can form combustible mixtures at temps. At or above flashpoint.
FIRE FIGHTING: Use water spray to cool fire-exposed surfaces & to protect personnel. Use foam, dry chemical, or water spray.

VI. STORAGE AND HANDLING

Keep container closed. Handle and open with care. Store in a cool, well-ventilated place away from incompatible materials. Do not handle or store near an open flame, heat, or other sources of ignition. Protect from direct sunlight.

VII. PERSONAL PROTECTION

Wear safety glasses with side shields, long sleeves and protective gloves.

IX. PHYSICAL AND CHEMICAL PROPERTIES

SPECIFIC GRAVITY (Water =1): 0.87 @ 68F VAPOR PRESSURE: 11mmHg @ 100 Degrees F
DENSITY: 7.3 lbs/gal at 59 FREEZING/MELTING POINT: -76 Degrees F / -60 Degrees C
BOILING POINT: 318 - 338 Degrees F / 159 - 170 Degrees C SOLUBILITY IN WATER: WT. % @ Deg.F.: 0.02 at 77 calculated EVAPORATION RATE: (Butyl Acetate = 1): 0.3 VISCOSITY OF LIQUID: cSt DegF: 0.9 at 77 (approximate)

X. REGULATORY INFORMATION

This product contains the following Section 313 Reportable Ingredients:
COMPONENT CAS NO. MAXIMUM %
1, 2, 4 – Trimethylbenzene 95-63-6 32.0
Xylene 1330-20-7 3.0
Cumene 98-82-8 1.5
Ethylbenzene 100-41-4 0.5

XI. OTHER INFORMATION

This information is for people trained in: National Paint & Coatings Association’s Hazardous Materials Identification System (HMIS), National Fire Protection Association (NFPA 704) Identification of the Fire Hazards of Materials.

NPCA-HMIS NFPA 704 KEY

Health 1 1 4 = Severe

Flammability 2 2 3 = Serious