Manufacturer: POR-15 Inc., P.O. Box 1235, Morristown, NJ 07962-1235 Telephone: 973-887-1999

Factory: 64 South Jefferson Road, Whippany, NJ 07981

Emergency Telephone No: 973-887-1999, 800-457-6715, 973-539-3236, Chemtrec 800-424-9300

PRODUCT NAME: Factory Manifold Gray Heat Resistant Paint FORMULA: Mixture/Composite blend

CHEMICAL NAME: Silicone Alkyd T.S.C.A. STATUS: N/A

CHEMICAL FAMILY: Alkyd TRADE NAMES/SYNONYMS: POR-15 Factory Manifold Gray HRP

II. HAZARDOUS INGREDIENTS

Naptha Petroleum (6833-23-3) * The last three potentially hazardous ingredients have been Current TLV:

Aluminum (7429-90-5) chemically reacted at high temp. and are homogenically and ionically ACGIH: 100ppm TWA

Manganese Oxide* (1309-37-1) interdiffused to create an essentially insoluble pigment. This means Ceiling Value OSHA (PEL): 500

Iron Oxide* (1309-37-1) they are not present in the form of simple physical mixtures.

Silicone Dioxide* (7631-86-9)

III. PHYSICAL DATA

BOILING POINT: 312 - 385 Degrees F / 155 – 196 Degrees C SPECIFIC GRAVITY: (Water = 1) 0.9076

VAPOR DENSITY: (Air = 1) 5.00 VAPOR PRESSURE (mmHg): 3.9 PSIA @ 163

REACTIVITY IN WATER: None MELTING POINT: None

SOLUBILITY IN WATER: Negligible VOLATILE ORGANICS: 2.33 lbs/gal (270 grams/liter)

APPEARANCE AND ODOR: Medium Gray / Light Aromatic VISCOSITY: Range @ 77o F/25o C: 200-500 CPS

IV. FIRE & EXPLOSION HAZARD DATA

FLASH POINT (Method used): TCC 108 Degrees F / 42.2 Degrees C

EXTINGUISHING MEDIA: Dry chemical (e.g. monoammonium phosphate, potassium sulfate, and potassium chloride, carbon dioxide, high expansion (proteninic) chemical foam, sand.

SPECIAL FIRE FIGHTING PROCEDURES/USUAL FIRE OR EXPLOSION HAZARDS: Full emergency equipment with self-contained breathing apparatus should be worn by firefighters.

HAZARD CLASS: B HEALTH: 3 FIRE: 2 REACTIVITY: 1 FLAMMABLE LIMITS LEL: 0.77% FLAMMABLE LIMITS UEL: 6% AUTO IGNITION TEMP: 475 Degrees F / 246 Degrees C

V. HEALTH HAZARD DATA

STABILITY: Stable under normal conditions.

CONDITIONS TO AVOID: Sparks, open flame, fire.

MATERIALS TO AVOID: Oxidizing agents like bleach, hydrogen peroxide.

HUMAN EFFECTS OF OVEREXPOSURE:

INHALATION: Excessive inhalation may cause irritation to nose, throat, and lungs.

SKIN: May cause irritation.

EYES: May cause severe irritation.

INGESTION: May be harmful if swallowed; irritation of mouth, pharynx, esophagus and stomach may develop following ingestion. Medical Conditions Generally Aggravated by Exposure: None known.

Carcinogens / Potential Carcinogens: None National Toxicology Program: No I.A.R.C. Monographs: No OSHA: No

VI. EMERGENCY & FIRST AID PROCEDURES

EYE CONTACT: Flush immediately with copious quantities of running water (low pressure) for at least 15 minutes, occasionally lifting eyelids; obtain medical attention.

INHALATION: Excessive inhalation may cause irritation to nose, throat, lungs. Remove to fresh air.

SKIN CONTACT: Remove contaminated clothing. Wash affected areas thoroughly with soap and water. Wash contaminated clothing before re-use.

INGESTION: Do not induce vomiting. Give one or two glasses of water to drink and refer to medical personnel, or take direction form either a physician or poison control center. DO NOT GIVE ANYTHING BY MOUTH TO AN UNCONSIOUS PERSON. Consult physician.

VII. PROTECTION RECOMMENDATIONS

EYE PROTECTION: Safety glasses with side shields, splash goggles or face shield. Contact lenses should not be worn.

SKIN PROTECTION: Chemical-resistant gloves. Cover as much of the exposed skin area as possible with appropriate clothing. If skin creams are used, keep the area covered to a minimum.

RESPIRATORY PROTECTION: An air-supplied respirator is strongly recommended for spray application. Observe OSHA regulations for respirator use 29 CFR, 1910.134.

VIII. SPILL OR LEAK PROCEDURES

POLYMERIZATION: None under normal conditions.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Keep away from heat, sparks, open flame; use with adequate ventilation. Avoid prolonged or repeated contact.

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLID: Provide ventilation and respiratory protection if required.

WASTE DISPOSAL METHODS: Incinerate under safe conditions or dispose of in accordance with local, state and federal regulations.

IX. SPECIAL PROTECTION

RESPIRATORY PROTECTION: NIOSH/MSHA approved respirator.

EYE PROTECTION: Safety goggles.

VENTILATION: Use in well-ventilated areas only. Have adequate general exhaust.

PROTECTIVE GLOVES: Solvent protective gloves.

OTHER PROTECTIVE EQUIPMENT: Self-contained breathing apparatus if threshold limit is exceeded.

X. SPECIAL PRECAUTIONS & STORAGE DATA

AVERAGE SHELF LIFE: 6 months to 2 years (unopened can) @ 77 degrees F (25 degrees C).

SPECIAL SENSITIVITY: (heat, light, moisture) If container is exposed to high heat, container may pressurize and burst. If moisture enters container pressure can build up due to reaction producing carbon dioxide, which might cause re-sealed container to pressurize and burst.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store in tightly closed container and protect from moisture contamination. Do not reseal if contamination is suspected. Ideal storage temperature range is 50-81 degrees F (10-27 degrees C).