Manufacturer: POR-15 Inc., P.O. Box 1235, Morristown, NJ 07962-1235 Telephone: 973-887-1999

Factory: 64 South Jefferson Road, Whippany, NJ 07981

PRODUCT DESCRIPTION: Clear colorless liquid

The composition of this mixture may be proprietary information. In the event of a medical emergency, compositional information will be provided to a physician or nurse. This product is hazardous as defined in 29 CFR 1910.1200, based on the following compositional information:

COMPONENT OSHA HAZARD

Xylenes, Ethylbenzene Flammable

Xylenes, Ethylbenzene OSHA PEL, ACGIH TLV

Xylene Eye irritant

For additional information, see Section 3

POTENTIAL HEALTH EFFECTS

EYE CONTACT: Slightly irritating but does not injure eye tissue.

SKIN CONTACT: Frequent or prolonged contact may irritate and cause dermatitis. Low order of toxicity. Skin contact may aggravate an existing dermatitis condition.

INHALATION: High vapor/aerosol concentrations (greater than approx. 1000ppm) are irritating to the eyes and respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death.

INGESTION: Small amounts of this product aspirated into the respiratory system during ingestion or vomiting may cause mild to severe pulmonary injury, possibly progressing to death. Minimal toxicity.

SKIN CONTACT: Flush with large amounts of water, use soap if available. Remove and wash contaminated clothing before re-use.

INHALATION: Immediately remove victim from exposure. Administer artificial respiration if breathing is stopped. Call for medical attention.

INGESTION: Do not induce vomiting. Keep at rest. Get prompt medical attention.

Auto Ignition Temperature: 932 Degrees F / 500 Degrees C NOTE: Approximate

FLAMMABLE LIMITS: LEL: 1.9 UEL: 12.3 @ 77 Degrees F / 25 Degrees C

GENERAL HAZARDS: Flammable liquid, can release vapor that forms flammable mixtures at temps. At or above flashpoint. Toxic gases will form at combustion. Hazardous combustion products: Fumes, smoke and carbon dioxide. Static discharge, material can accumulate static charges, which can cause an incendiary electrical discharge.

FIRE FIGHTING: Use water spray to cool fire-exposed surfaces & to protect personnel. Use foam, dry chemical, or water spray.

Keep container closed. Handle and open containers with care. Store in a cool, well-ventilated place away from incompatible materials. Do not handle or store near an open flame, heat, or other sources of ignition. Protect from direct sunlight.

Wear safety glasses with side shields, long sleeves and protective gloves.

SPECIFIC GRAVITY (Water =1): 0.87 @ 60F VAPOUR PRESSURE: 11mmHg @ 100 Degrees F, 4 mmHg @ 68 Degrees F

DENSITY: 7.3 lbs/gal at 59 FREEZING/MELTING POINT: -76 Degrees F / -60 Degrees C

BOILING POINT: 318 - 338 Degrees F / 159 - 170 Degrees C SOLUBILITY IN WATER: WT. % @ Deg.F.: 0.02 at 77 calculated EVAPORATION RATE: (Butyl Acetate = 1): 0.3 VISCOSITY OF LIQUID: cSt DegF: 0.9 at 77 (approximate)

This product contains the following Section 313 Reportable Ingredients:

Xylene 1330-20-7 85%

This information is for people trained in: National Paint & Coatings Association’s Hazardous Materials Identification System (HMIS), National Fire Protection Association (NFPA 704) Identification of the Fire Hazards of Materials.

Health 2 2 4 = Severe

Flammability 3 3 3 = Serious

2 = Moderate

1 = Slight